Table of Contents
If you don’t know how to adjust garage door tracks, then there’s no need to panic.
It’s normal for a garage door track to be misaligned, and it’s also normal for homeowners not to know how to fix it.
However, it is important for us to be aware and attentive to what is happening to our garage door.
Even if you employ the most expensive brand of garage door there is, it is still bound to cause problems.
It can malfunction and get damaged eventually, whether we like it or not.
As such, we always recommend maintenance and tune-ups every once in a while.
Caring for your garage door, although it won’t completely save the garage door from sinking into despair, especially if it is old, can prevent malfunction.
Yet, garage door tracks may need adjusting after a long time of use.
These tracks also go through a lot as a guide for the lowering and the opening of the garage door.
Hence, if you are looking for a solution on how o adjust garage door tracks, we got you covered.
Just remember, however, it is better to entrust the adjustments to the garage door repair in San Antonio.
This is important for safety as well as productive results.
Here are some of the steps that you can follow in making sure that the garage door tracks are back into place:
Step One: Unfastening the track screws.
The first step is to ensure first that the garage door has been secured properly in its tracks.
After that, just loosen the screws with the help of a screwdriver.
This will bind the tracks in the garage door frame.
Step Two: Adjusting the position of the door.
By means of a rubber mallet, tap the end of the track and ensure that it is in a vertical position.
To ensure effectiveness, make use of a spirit level to have the perfect alignment of the tracks confirmed.
Step Three: Fastening the screws.
Once you have confirmed that the track is now on the correct alignment, just fasten the screws to make sure that the tracks won’t move.
Step Four: Making adjustments to the other track.
Once you have had the other track adjusted, you’ll need to move on to the other one.
Just make use of the rubber mallet once again and tap the end of the track.
Make sure that it is aligned straight.
Afterward, fasten the screws.
Using these four steps, you can easily know how to adjust garage door tracks by yourself.
However, keep in mind that if you are not confident, call for a garage door repair in San Antonio immediately.
However, if you have tracks that are rubbing against the rubber molding, or else a gap is noticeable between them, then you can follow the steps below:
Step Five: Loosening the bolts.
The first thing that you need to do is to have the bolts loosened, which secures the tracks to the track bracket by means of a wrench.
Before you move on to the other steps, you have to verify first if the bolts on both tracks have been loosened.
Step Six: Adjusting the gap.
Simply place one of the tracks left or right until a gap is left of about one-fourth inch, which is between the stop molding as well as the gap.
Keep in mind that the gap should be similar.
Do the same for the other track on the opposite side.
Step Seven: Tightening the bolts.
Lately, you only need to tighten the track bolts by using a wrench.
Confirm first that these bolts have been secured well.
However, you need to ensure that they are not too tight.
Call Alamo City Garage Pros
Don’t know how to adjust garage door tracks?
No need to worry!
Alamo City Garage Pros is the right company for you.
We are a company of garage door professionals who specialize in offering garage door repair in
San Antonio and garage door installation in San Antonio.
As experienced professionals, we guarantee only the best kind of service there is, as proven
and tested by our previous customers.
Don’t hesitate to call us!
For how to adjust garage door tracks, contact Alamo City Garage Pros.
Call us now!
