Table of Contents
It is imperative to have sufficient knowledge when it comes to garage door track adjustment.
For instance, you need to know that the track is linked to the frame of the door using metal clips.
As a result, it allows the rollers to have the garage door slide with proper guidance.
Consequently, a garage door track adjustment includes setting the track to its proper alignment with the rollers.
In such a task, however, a garage door repair in San Antonio should be called.
For guidance, here are some steps in a garage door track adjustment:
Step one: Ensuring your safety.
Before attempting to adjust the track of the garage door, you will need to close the door first.
For this, simply loosen one track at a time.
Take care not to remove the entire lag bolts.
Just loosen these bolts that are fastening the track to the jamb.
Then, slide the bracket up until it has reached the right distance.
Moreover, more than one of the clips needs to be loosened, and then get the track positioned in the right location upon securing the clips.
Make sure, however, that the lag bolts are secured as it attaches the clips to the framing.
Step two: Adjusting the tracks.
This is where you formally start the job of a garage door track adjustment.
Remember that the overhead area of the garage door track only contains one point for adjustment.
Hence, the track should have the same distance that is away from the door similar to the wall track.
You should not try to adjust the track while the door is still open.
There are brackets that are holding the track up, which have slots and other holes in them.
The rear of the track will also have to be moved in order for it to be adjusted.
Simply have the bolts loosened or removed if a new hole will need to be used.
Just move the rear of the track closer or far away from the door as much as it is needed.
However, do not have it moved far.
When the track is too far from the door, the garage door itself could fall.
Moreover, a closer track can also cause the door to bind. Have the rear of the track moved and then test the door.
The track should be in parallel with the garage door.
Fasten the bolts and then test the operation of the door.
For safety precautions, do not stand below the door and then inspect it for any binding or loosening of the door.
A garage door track adjustment for the overhead area is the same as adjusting the tracks on the side of the door.
The only difference is that you only have one place to adjust the track at.
If the overhead garage door track has not been bent, then these steps should work for you.
The rear ends of the tracks of the garage door are held in position by the metal angles that are attached to the rafters or the ceiling.
These angles have holes, with some being slotted and some being not.
The thing is, you have to place the track in parallel to the door in its open position.
Step three: Adjusting the weatherstripping.
If notice that there is something wrong with the weatherstripping, you should also pay attention to it.
You can see that there are significant bolt holts that are slotted in order for the track to be connected to the clip.
This, except for the top clip.
Whenever the closes, it must also touch the weatherstripping.
Call Alamo City Garage Pros
Do you need a garage door track adjustment?
No need to worry!
The solution is right here.
Alamo City Garage Pros is the right company for you.
We are a company of garage door professionals who specialize in offering garage door repair in
San Antonio and garage door installation in San Antonio.
As experienced professionals, we guarantee only the best kind of service there is, as proven
and tested by our previous customers.
Don’t hesitate to call us!
For a garage door track adjustment, contact Alamo City Garage Pros.
Call us now!
