Table of Contents
A homeowner that is installing a new garage door in San Antonio must only trust a professional.
These professionals are far better suited to such a heavy and quite dangerous task.
Hence, it is without question that you should contact a garage door installation in San Antonio for this.
Given that, here are the steps that should be followed when installing a new garage door in San Antonio:
Step One: Relieving the door’s tension.
For the first step, you need to relieve the door first of its tension.
Remember to exercise caution, given that the springs carry a great amount of weight, in addition to the tension itself.
Hence, handling it improperly can cause you injury and damage.
Thus, before working on the installation, make sure that the tension is relieved from the torsion springs first.
Step Two: Disconnecting the opener.
In installing a new garage door in Baltimore, it is necessary that you unplug the opener after you have secured the release of the tension from the springs.
In order to safely unplug it, all you need to do is pull the red emergency cord.
This action will move the arm of the trolley vertically so that you can raise or lower the door using your bare hands.
After this has been done, you can now begin the removal of the sectional door panels.
Step Three: Installing the panels.
When you are done making sure that the above-mentioned steps have been completed, you can now start the installation of the new garage door.
If you are replacing a garage door with two cars, then you should place a reinforcing bar at the top panel so as to prevent any bowing that is in the center.
Afterwards, you can drill the pilot holes if it has not been drilled by the manufacturer itself.
Then, simply utilize the screws in order to have the bar secured to the panel.
Step Four: Tightening the hinges, installing the tracks.
The next thing to do is to secure the top of each of the hinges on top of the top panel.
Then, put the wheel axles on the hinges from both sides.
After that, you can then install the top as well as the bottom axle supports.
Next, have the track installed and make sure that the wheels all lie rightfully in the track so as to make sure that it has proper functionality.
Lastly, simply attach the cable of the door to the hook that is found on the panel axle support that you can locate at the bottom.
Then, put the bottom bracket against the wall.
Step Five: Installing the spring.
For this step, you should assemble the pieces that will support the spring and affix it to the track.
Afterward, use the ceiling from the support of the previous door.
Then, rest the section of the track that is curved on the vertical piece that has been made earlier.
Then, fasten the other rear to the bracket at the ceiling.
Step Six: Securing the tracks together.
This step will require you to align the horizontal and vertical tracks.
You need to affix these tracks to the door and bolt them together.
Step Six: Placing the springs.
In installing a new garage door in San Antonio, the succeeding step is to link the spring anchors to the springs and affix a locking cone on them.
After that, you need to fasten them securely to the header bracket.
Step Seven: Affixing the torsion rod and pulleys.
In installing the torsion rod, just have it slide onto the holes, which are located on one side of the header brackets.
Afterward, attach the pulleys to each end of the rod.
Then, affix the cable and fasten the springs.
Call Alamo City Garage Pros
If you are installing a new garage door in San Antonio, no need to worry!
Alamo City Garage Pros is the right company for you.
We are a company of garage door professionals who specialize in offering garage door repair in
San Antonio and garage door installation in San Antonio.
As experienced professionals, we guarantee only the best kind of service there is, as proven
and tested by our previous customers.
Don’t hesitate to call us!
In installing a new garage door in San Antonio, contact Alamo City Garage Pros.
Call us now!
